An Emgrand EC7 wrapped in green starts with a color change decision between matte, satin, gloss, and special finishes. Matte film hides reflections and gives the panels a flat, almost military look. Satin sits between matte and gloss with a soft sheen that is easy to keep clean. Gloss film looks most like a deep wet paint job and adds a lot of reflectivity.

Factory paint on this car is the base for the wrap, so any rust or deep scratches must be repaired first. The installer cuts the film to follow each panel edge, and seams are placed along body lines or shut lines. On the EC7's tailgate the film ends at the edge of the rear glass because the glass is part of the tailgate. Seams are less noticeable on darker colors like green than on bright silver.

A green wrap is removable, and a professional install leaves the factory paint as it was before. Hand wash with a soft sponge and pH-neutral car shampoo to protect edges and seams. Avoid pressure washers pointed at film edges, especially around parking sensors and fog lamp cut-outs. The film can be removed later without leaving adhesive when it is taken off by a trained installer.