A Haima 3 wrapped in blue starts with a finish choice, then a film inside that finish. The first-generation hatchback and sedan measure 170.9 in (4,342 mm) to 175.8 in (4,466 mm), so a color change needs about 54–56 ft (16.5–17 m) of 60-inch cast film. Partial panels like the roof or hood need less film and labor. The tailgate has the rear glass in it, so the film ends at the edge of the glass.

Factory paint condition decides how much preparation a Haima 3 blue wrap needs. A clean, smooth surface lets film lay flat without seams telegraphing chips or scratches. Seams on this car fall at panel edges, not across large flat areas. The installer can hide them along the tailgate and door gaps.

A removable blue wrap protects the Haima 3 from sun and minor abrasion while it is on. Removal uses heat and leaves the factory paint as it was when the film was applied. Hand wash with mild soap and a soft mitt, and avoid automatic brushes. The wrap lifts only if it was installed over damaged paint or poor preparation.