Wraps by car

Hanomag Rekord wrap

The Hanomag Rekord wrap guide covers the first generation of this mid-size coupe, produced from 1934 to 1940. A full vinyl wrap of the two-door body takes about 49 ft (15 m) of 60-inch (1.52 m) cast film. With chrome or patterned film, plan on about 57 ft (17.5 m). This page explains what the body style means for installation and which smaller jobs are practical.

1generations15 mof film for a full wrap

Hanomag Rekord, first generation, factory photo
Hanomag Rekord, first generation. Factory color shown.

Hanomag Rekord wrap colors and ideas

  • Rekord black wrap
  • Rekord white wrap
  • Rekord gray wrap
  • Rekord silver wrap
  • Rekord red wrap
  • Rekord blue wrap
  • Rekord green wrap
  • Rekord yellow wrap
  • Rekord orange wrap
  • Rekord purple wrap
  • Rekord pink wrap
  • Rekord teal wrap
  • Rekord brown wrap
  • Rekord gold wrap
  • Rekord chrome wrap
  • Rekord color shift wrap
  • Rekord carbon fiber wrap
  • Rekord camo and patterned wrap

How much vinyl to wrap a Hanomag Rekord

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1934–1940coupe (2 doors)167.3 in (4,250 mm)about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

Rekord wrap cost factors

Rekord wrap cost is set by the size of the car, the film type, and the condition of the paint. This coupe is 167.3 in (4,250 mm) long and uses about 49 ft (15 m) of cast film for a full wrap. Paint protection film (PPF) on the front end uses less material but adds extra time for trimming edges. The two long doors are each one large piece, so a clean install needs more labor than a body with short panels.

  • Film for a full wrap: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Rekord wraps by generation

Swipe sideways. Tap a card for the full description.

Hanomag Rekord, first generation, factory photo
Factory color shown

1934–1940 Rekord coupe (first generation)

1934–1940coupe (2 doors)167.3 in (4,250 mm)

The first generation Hanomag Rekord, built from 1934 to 1940, is a mid-size coupe with two doors and a length of 167.3 in (4,250 mm). Because the car is from these years, the panels may be original or repainted, and a test spot comes before a full wrap. This checks that the film will stick and remove cleanly without lifting old paint. The body style is simple, with no complex bumpers or roof rails to work around.

Two long side doors: each door is one large piece of film.

Film: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Rekord

A partial wrap on a Hanomag Rekord lets you cover only the roof, hood, or mirror caps. A chrome delete on the window trim and badges is another option that uses black film. Paint protection film (PPF) on the front end is a clear layer that guards against stone chips. These smaller jobs need less material than the full-body figure of about 49 ft (15 m).

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Hanomag Rekord: body, cut-outs and film

The Hanomag Rekord vinyl wrap starts with a single coupe body style with two long side doors. The car is 167.3 in (4,250 mm) long, so the roof and rear quarter panels are moderate in size. Each door is one large piece of film, which calls for a steady hand and careful stretching. Wrapping the complete car uses about 49 ft (15 m) of standard cast film.

Rekord wrap ideas focus on the two long doors and the bright trim around the glass. The window surrounds and badges are wrapped with black film for a chrome delete, or covered in the body color for a subtle look. The mirror caps are small enough to match or contrast with the main film. No bumpers or large grilles need to be removed for a color change wrap on this car.

How much vinyl to wrap a Rekord depends on which generation you are working on. This catalog shows one generation, the 1934–1940 coupe, which needs about 49 ft (15 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film for accents, the estimate rises to about 57 ft (17.5 m). A second generation is not listed here, so the figure does not change between model years.

More Hanomag wraps

Questions about wrapping a Hanomag Rekord

How much vinyl does it take to wrap a Hanomag Rekord?

It takes about 49 ft (15 m) of 60-inch (1.52 m) cast film to wrap a Hanomag Rekord. This is the estimate for the first generation coupe, the only generation in this catalog. If you add chrome or patterned film accents, the total is about 57 ft (17.5 m). The figure covers the whole exterior of the two-door body.

Can I wrap only the hood or the roof of a Rekord?

Yes, you can wrap only the hood or the roof of a Rekord. The partial jobs listed for this car include the roof, hood, mirror caps, and a chrome delete on the window trim and badges. Paint protection film (PPF) on the front end is another clear option. These smaller areas need less film than the full wrap estimate of about 49 ft (15 m).

Is a Rekord hard to wrap?

A Rekord is moderately hard to wrap because of its two long side doors and its age. Each door is one large piece of film, so you need to handle a big panel without wrinkles. The car is 167.3 in (4,250 mm) long, which adds surface area but no complex curves. The paint may be original or repainted, so a test spot is necessary before any full vinyl wrap.

How many generations of the Rekord does this page cover?

This page covers one generation of the Rekord, the first generation produced from 1934 to 1940. The catalog shows a single body style, a two-door coupe, for these years. No second generation is listed, so all film estimates on this page refer to that coupe. The generation count is stated in the lead of this guide.