Deciding on a Monster wrapped in green starts with the finish, because matte, satin, and gloss each need a different film line. Then pick the exact film from the groups below, named by their factory color and finish. A color change wrap covers every painted panel, so the owner must decide between a full wrap and a partial job. Finish affects depth of color: gloss reads as liquid paint, while matte reads as a flat, soft surface.

The factory paint stays under the film and is not altered, but every wrap leaves seams where panels meet. On the Haval Monster the largest seams run along the roof rails and around the tailgate opening, and the film ends at the edge of the glass. Seams are less visible on a satin or matte film than on a high gloss, because gloss reflects light along the cut edge. Installers trim the film on the inside edges of doors and hood to hide the cut line.

A green wrap is removable, so the body returns to factory paint when the film is taken off by an installer. Care is simple: hand wash with a soft mitt and a pH-neutral soap, then rinse without a pressure washer closer than 30 cm. Avoid automatic brush washes and solvent cleaners, which can lift film edges and damage the finish. The adhesive releases with controlled heat, and that process does not depend on the film being green.