Choosing a color shift film for the e starts with the finish rather than a single shade. The e wrapped in color shift film shifts between two or more tones, so the same car reads differently from the front, side and back. This color change is achieved with a special pigment in the film, not by changing the paint underneath. For this body you can pick a subtle white-to-gray shift or a strong purple-to-green transition.

The factory paint under a color shift wrap stays hidden, but its condition decides how much preparation the job needs. Any scratch, chip or area of peeling clear coat will show through the film as a raised line. The wrap installer may fill and sand small flaws first. Seams are planned along body lines and the tailgate edge, because the rear glass is set into the rear hatch and film cannot wrap over glass.

Color shift film on the e is removable, so the car can return to its factory paint later. Hand wash the wrapped car with a soft sponge and a mild automotive soap. Avoid pressure washers directed at film edges, especially around the charge port door and tailgate seams. When you sell the car, you can keep the wrap or have it removed without affecting the paint underneath when done by a qualified installer.