A Veloster wrapped in yellow starts with a decision between matte, satin and gloss finishes. Gloss sits closest to a factory paint look, while matte removes reflections and satin sits between them. Metallic and glitter films add depth but are pictured separately below. Your choice of finish changes how the car's curved tailgate and bumper cut-outs read in daylight.
Factory paint on a Veloster is prepared before any yellow film is applied. Older panels may be repainted, so a test spot on each panel shows whether the film will bond cleanly. Seams in the film are placed at panel edges and body lines, and the tailgate ends at the edge of the rear glass. The fog lamps in the front bumper require cut-outs in the film on every trim.
A yellow wrap on the Veloster is removable and should be cared for by hand wash. Avoid automatic brushes and high-pressure jets close to film edges and the fog lamp cut-outs. The film can be removed later without changing the factory paint when it was prepared correctly. Use a soft sponge and a pH-neutral car shampoo.
