Wraps by car

Jensen S-V8 wrap

The Jensen S-V8 wrap uses about 41 ft (12.5 m) of 60-inch (1.52 m) cast film for a full color change on the single-generation convertible. This page covers the vinyl wrap material needed, where body panels end, and how the one available generation affects the job. Information on partial wraps, chrome delete, and paint protection film is included without pricing or shop references.

1generations12.5 mof film for a full wrap

Jensen S-V8, first generation, factory photo
Jensen S-V8, first generation. Factory color shown.

Jensen S-V8 wrap colors and ideas

  • S-V8 black wrap
  • S-V8 white wrap
  • S-V8 gray wrap
  • S-V8 silver wrap
  • S-V8 red wrap
  • S-V8 blue wrap
  • S-V8 green wrap
  • S-V8 yellow wrap
  • S-V8 orange wrap
  • S-V8 purple wrap
  • S-V8 pink wrap
  • S-V8 teal wrap
  • S-V8 brown wrap
  • S-V8 gold wrap
  • S-V8 chrome wrap
  • S-V8 color shift wrap
  • S-V8 carbon fiber wrap
  • S-V8 camo and patterned wrap

How much vinyl to wrap a Jensen S-V8

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2001–2003convertible (2 doors)163.9 in (4,163 mm)about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)

S-V8 wrap cost factors

S-V8 wrap cost depends on the body area wrapped, the film type, and the trim detail on this two-door convertible. The full wrap needs about 41 ft (12.5 m) of 60-inch cast film, and the figure rises to about 49 ft (15 m) for a patterned or chrome film. The number of cut-outs and whether the convertible top edges are finished with knifeless tape also changes the work time. Labor on the one available body style is consistent, but partial jobs reduce both material and labor.

  • Film for a full wrap: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

S-V8 wraps by generation

Swipe sideways. Tap a card for the full description.

Jensen S-V8, first generation, factory photo
Factory color shown

2001–2003 S-V8 convertible (first generation)

2001–2003convertible (2 doors)163.9 in (4,163 mm)

The first-generation Jensen S-V8 from 2001 to 2003 has only a convertible body, so the wrap specialist never works around a fixed roof. The fabric top is left unwrapped, and the vinyl ends at the beltline where the roof mechanism meets the body. The film also stops under the tonneau cover line if a hard boot is fitted. The 163.9 in (4,163 mm) length means one installer can handle each panel without seams on the hood.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 41 ft (12.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Roof, hood, chrome delete and PPF on an S-V8

S-V8 chrome delete covers the window trim and badges with black film instead of wrapping the whole car. A partial wrap on this Jensen can include the hood, mirror caps, and rear deck, leaving the doors and fenders in original paint. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. All three options use less film than a full wrap and still change the look or protect the body.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Jensen S-V8: body, cut-outs and film

The Jensen S-V8 vinyl wrap fits a 163.9 in (4,163 mm) convertible with two doors. Because the body has one style only, the film estimate stays the same for all S-V8s. The open top means the wrap ends at the base of the roof opening, not over the fabric. The one-generation catalog makes planning simpler than on cars with multiple body shapes.

S-V8 wrap ideas start with which parts need cut-outs to keep the car usable. Door handles, side markers, and badges are trimmed out or removed and rewrapped if required. The convertible top is not wrapped, and the film ends where the vinyl roof begins. Panel gaps around the doors and trunk add to the trimming time.

How much vinyl to wrap an S-V8 does not change from year to year because the catalog shows only one generation, from 2001 to 2003. A full wrap uses about 41 ft (12.5 m) of standard 60-inch film, while chrome or patterned vinyl needs about 49 ft (15 m). The extra material on the patterned film covers waste from aligning the design across the body curves. Any S-V8 owner can use the same amount, regardless of the production year.

More Jensen wraps

Questions about wrapping a Jensen S-V8

How much vinyl does it take to wrap a Jensen S-V8?

A Jensen S-V8 needs about 41 ft (12.5 m) of 60-inch (1.52 m) cast film for a complete color change. If you choose chrome or patterned film, plan on about 49 ft (15 m) because the pattern must be matched across the curved panels. The same amounts apply to every model year of this single-generation car.

Is the top of an S-V8 wrapped?

No, the fabric top of an S-V8 is not wrapped because the film is designed for rigid panels and would not flex with the folding mechanism. The vinyl ends exactly where the body meets the top frame, just under the beltline trim. If the car has a removable hard top, that top is wrapped only when detached from the car, as a separate panel.

Can I wrap only the hood or the roof of an S-V8?

Yes, you can wrap only the hood or the rear deck on an S-V8 without doing the whole car. A partial wrap often includes the hood, mirror caps, and rear deck, while a chrome delete covers just the window trim and badges. The roof is not wrapped because the car has a fabric convertible top rather than a metal roof.

Is an S-V8 hard to wrap?

The S-V8 is not the hardest car to wrap, but the convertible body and the two-door length of 163.9 in (4,163 mm) add some labor. The main extra work is cutting the film cleanly where the fabric top meets the body and trimming around the door handles and small trim pieces. The single body style means no coupe or sedan variations to adjust for, and the panels are large enough to avoid complex seams.