A One:1 wrapped in camo or patterned film starts with the finish you want, then the film line, then a full color change or a smaller job. You will see how each finish reads different on this car's wide, low body. The long doors and smooth flanks let the pattern run across large surfaces without interruption.

Factory paint is protected under any of these films, so the original color stays clean and untouched. Seams fall along panel edges or body lines, and the installer plans them around the doors and cameras. A clean install on the One:1 means no visible edges on the large side panels.

All these camo and patterned films are removable, and a careful removal leaves the paint as it was. Hand wash the car after the wrap, because a pressure washer can lift an edge. Use a soft mitt and a mild soap, and avoid wax on the film.