A Ypsilon wrapped in carbon fiber film starts with a finish decision between a repeating weave and forged carbon. The finish sets the look, while the film line sets how the film behaves during installation and how much texture it shows. A partial color change on the roof and mirror caps uses far less film than a full wrap. Every finish group on this page lists the films that fit the car.
Factory paint is the base for a wrap, so any paint damage, rust or deep chips must be repaired before the film goes on. On the Ypsilon the tailgate holds the rear glass, so the film ends at the edge of the glass instead of wrapping around it. Seams are placed along panel edges or character lines, and on this car the long doors of the first and second generations are each one large piece of film. The film needs a clean, smooth surface to lie flat and hold.
Removable film means the vinyl can be taken off later without leaving adhesive on the paint. Hand washing is the safe cleaning method for a wrapped car, because pressure washers can lift the edges of the film. Use a soft sponge and a mild soap, and avoid waxes with petroleum solvents. The wrap should be dried with a clean microfiber cloth to prevent water spots.


