Choosing a finish for a Ypsilon wrapped in yellow starts with the sheen you want, because matte, satin and gloss film all cut and install the same way on this car. Next pick a film line from the 102 options, knowing that chrome or patterned rolls add about 10 ft (3 m) to the film estimate. Then decide whether to wrap the full body or start with a partial color change on panels like the roof and hood. Every finish brings the same bright yellow hue, but the surface effect changes how the car reads in daylight.

On the Ypsilon, yellow wrap film covers the factory paint completely, so the original color shows only in shut lines and hidden edges. The rear glass sits in the tailgate, which means the film stops cleanly at the edge of the glass and cuts down the number of visible seams. Some trims have fog lamps in the front bumper, so the installer adds cut-outs in the bumper film around those lamps. Clean panel gaps on this small hatchback help the wrap look close to a repaint.

A yellow wrap on the Ypsilon is removable, and it leaves the factory paint underneath untouched when the film was applied to sound paint. Care after the wrap is straightforward: hand wash the car with a mild soap and a soft sponge instead of an automatic brush wash. The film does not need wax or sealant, so maintenance stays simple. If you later remove the wrap, the painted surface goes back to its original color.