Wraps by car

Marcos Marcasite wrap

The Marcos Marcasite wrap page covers the single-generation 2002–2007 convertible and the film a full wrap takes. A complete color change uses about 38 ft (11.5 m) of 60-inch (1.52 m) cast film. Choosing chrome or patterned film raises the estimate to about 43 ft (13 m). This sports car's open top and short production run make its wrap planning distinctive.

1generations11.5 mof film for a full wrap

Marcos Marcasite, first generation, factory photo
Marcos Marcasite, first generation. Factory color shown.

Marcos Marcasite wrap colors and ideas

  • Marcasite black wrap
  • Marcasite white wrap
  • Marcasite gray wrap
  • Marcasite silver wrap
  • Marcasite red wrap
  • Marcasite blue wrap
  • Marcasite green wrap
  • Marcasite yellow wrap
  • Marcasite orange wrap
  • Marcasite purple wrap
  • Marcasite pink wrap
  • Marcasite teal wrap
  • Marcasite brown wrap
  • Marcasite gold wrap
  • Marcasite chrome wrap
  • Marcasite color shift wrap
  • Marcasite carbon fiber wrap
  • Marcasite camo and patterned wrap

How much vinyl to wrap a Marcos Marcasite

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2002–2007convertible (2 doors)157.7 in (4,005 mm)about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m)

Marcasite wrap cost factors

Marcasite wrap cost is driven by the film amount and the prep work for this model. The estimate of 38 ft (11.5 m) of 60-inch film sets the base material need, while chrome or patterned film raises it to 43 ft (13 m). Labor increases with the convertible body because the installer must mask and trim around the soft top. The car's two-door layout reduces the number of handles and trim pieces to remove.

  • Film for a full wrap: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Marcasite wraps by generation

Swipe sideways. Tap a card for the full description.

Marcos Marcasite, first generation, factory photo
Factory color shown

2002–2007 Marcasite convertible (first generation)

2002–2007convertible (2 doors)157.7 in (4,005 mm)

The open top of the first generation Marcos Marcasite is not wrapped with vinyl. If the top is fabric, the film ends where the fabric begins, leaving the top uncovered. A folding hard top would be wrapped as separate panels of its own. This keeps the wrap lines clean and avoids damaging the top mechanism.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m).

Roof, hood, chrome delete and PPF on a Marcasite

A partial wrap on a Marcos Marcasite can cover the hood, mirror caps, and rear deck. Chrome delete is done by covering the window trim and badges with black film. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. These smaller jobs use less film than a full color change wrap.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Marcos Marcasite: body, cut-outs and film

A Marcos Marcasite vinyl wrap must account for the convertible body and compact 157.7 in (4,005 mm) length. The fabric top is not wrapped, so film is needed only for the lower body panels. Because the car has two doors, the side coverage is straightforward and uses less film than a four-door. The rear deck behind the seats is wrapped as part of the main body.

Marcasite wrap ideas begin with the parts that need extra work. The convertible body means the film ends cleanly where the fabric top begins, with no roof panel to cover. Door handles and badges are removed or carefully cut around for a smooth finish. The mirrors and front bumper also need precise trimming around their curves.

How much vinyl to wrap a Marcasite depends mainly on the single body style. There is only one generation, from 2002 to 2007, so the measurements do not change between years. A full wrap takes about 38 ft (11.5 m) of 60-inch film, or about 43 ft (13 m) for chrome or patterned film. The compact size keeps the total film requirement lower than for larger sports cars.

Questions about wrapping a Marcos Marcasite

How much vinyl does it take to wrap a Marcos Marcasite?

It takes about 38 ft (11.5 m) of 60-inch (1.52 m) cast film to wrap a Marcos Marcasite. A chrome or patterned film wrap requires about 43 ft (13 m) of the 60-inch film. The lower figure is enough for a standard color change on this two-door convertible.

Is the top of a Marcasite wrapped?

No, the fabric top of a Marcos Marcasite is not wrapped. The vinyl film ends where the fabric top begins, so the roof remains uncovered. If the car had a folding hard top, that top would be wrapped as separate panels.

Can I wrap only the hood or the roof of a Marcasite?

Yes, you can wrap only the hood or the rear deck of a Marcos Marcasite. A partial wrap often includes the hood, mirror caps, and rear deck. These small areas are handled separately from a full body wrap.

Is a Marcasite hard to wrap?

A Marcos Marcasite adds work because of its convertible body and small size. The installer must trim the film precisely where the top meets the body. The 157.7 in (4,005 mm) length and curved rear deck require careful fitting of the film.