A Quattroporte wrapped in silver is a full color change that replaces the visible exterior color without repainting. Start with the finish: matte tones the brightwork down, satin has a low sheen, and gloss reflects like clearcoat. Then pick a film from this page and decide between a full wrap and partial panels. The film amount and labor depend on the generation and its wheelbase.
Factory paint on every Quattroporte stays under the film during the wrap, which is the point of a color change. On this car the bumpers, mirrors and lower sills are where seams can show, because the panel shapes pull film in different directions. A good installer plans seam placement before cutting so they follow body lines. The large hood and roof on a 207.2 in (5,262 mm) sedan need two people to lay film flat.
A silver wrap on the Quattroporte is removable by design, so a leased car can go back to factory paint. Hand wash the wrapped sedan with a mild soap and a soft mitt, and do not use automatic car washes with brushes. Avoid pressure washers close to edges and seams. This keeps the film bonded and the color even.



