A McLaren 600LT wrapped in yellow changes the car's color without a paint booth, and the 600LT has two long side doors that each take one large piece of film. Finish is your first decision: matte yellow looks flat and smooth on this car, satin yellow has a low sheen, and gloss yellow reflects like a clear-coated paint. The film brand and its exact shade come second, since the same yellow can differ among 16 brands. After that you can choose a full wrap or a smaller job such as the hood or mirror caps.

Factory paint under a yellow wrap stays protected, but the way the car is built decides where the seams of the vinyl must run. On a 600LT with a fabric top the film ends where the fabric begins, and a folding hard top is wrapped as separate panels of its own. The long doors are each covered as one piece without a seam in the middle. The 600LT is 181.3 in (4,604 mm) long, so a coupe wrap needs about 52 ft (16 m) of 60-inch (1.52 m) film and a convertible about 46 ft (14 m). Chrome or patterned film can raise that figure to about 59 ft (18 m).

A yellow wrap on a 600LT is removable when the time comes, so the car can go back to its original color. Washing by hand is the safe way to keep the film clean, and you avoid the pressure of automatic brushes. The film does not bond to the paint like a new coat of color, which makes removal possible. On this car the fabric top is not wrapped, so there is less film to remove than on a fixed-roof car.