Wraps by car

Mercedes SLK-Class wrap

This page covers the Mercedes SLK-Class wrap across three generations, from 1996 to 2020. A full vinyl wrap of the newest body takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds roughly 5 ft (1.5 m) to that estimate. Every generation is a two-door convertible, which shapes how the film is cut and fitted.

3generations13.5 mof film for a full wrap

Mercedes SLK-Class, third generation, factory photo
Mercedes SLK-Class, third generation. Factory color shown.

Mercedes SLK-Class wrap colors and ideas

  • SLK-Class black wrap
  • SLK-Class white wrap
  • SLK-Class gray wrap
  • SLK-Class silver wrap
  • SLK-Class red wrap
  • SLK-Class blue wrap
  • SLK-Class green wrap
  • SLK-Class yellow wrap
  • SLK-Class orange wrap
  • SLK-Class purple wrap
  • SLK-Class pink wrap
  • SLK-Class teal wrap
  • SLK-Class brown wrap
  • SLK-Class gold wrap
  • SLK-Class chrome wrap
  • SLK-Class color shift wrap
  • SLK-Class carbon fiber wrap
  • SLK-Class camo and patterned wrap

How much vinyl to wrap a Mercedes SLK-Class

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2011–2020convertible (2 doors)162.8 in (4,134 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)
2004–2011convertible (2 doors)160.7 in (4,082 mm) to 161.5 in (4,103 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)
1996–2004convertible (2 doors)157.3 in (3,995 mm) to 157.9 in (4,011 mm)about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m)

SLK-Class wrap cost factors

SLK-Class wrap cost depends on the generation, the film type, and the condition of the paint. A newer third-generation car takes more film than a first-generation car, and chrome or patterned film increases the amount you need. Any paint repair or spot priming adds preparation time before the wrap. The number of cut-outs for sensors and fog lamps also affects the labor.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.
  • Every trim has parking sensors in the bumpers: the film is cut around each sensor.
  • Every trim has fog lamps in the front bumper: cut-outs in the bumper film.

SLK-Class wraps by generation

Swipe sideways. Tap a card for the full description.

Mercedes SLK-Class, third generation, factory photo
Factory color shown

2011–2020 SLK-Class convertible (third generation)

2011–2020convertible (2 doors)162.8 in (4,134 mm)

On the third-generation SLK-Class, the open top is not wrapped, and the film ends where the top begins. A fabric top is left untouched, while a folding hard top is wrapped as panels of its own. Every trim has parking sensors in the bumpers, so the film is cut around each sensor. Fog lamps in the front bumper also require cut-outs in the film.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Every trim has parking sensors in the bumpers: the film is cut around each sensor.

Every trim has fog lamps in the front bumper: cut-outs in the bumper film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Mercedes SLK-Class, second generation, factory photo
Factory color shown

2004–2011 SLK-Class convertible (second generation)

2004–2011convertible (2 doors)160.7 in (4,082 mm) to 161.5 in (4,103 mm)

The 2007 restyling of the second-generation SLK-Class changed the bumpers and lights. Film cut for a pre-2007 bumper will not fit a post-2007 bumper without rework. The convertible body still has a top that is not wrapped, and fog lamps in the front bumper need cut-outs. Length stayed close to 160.7 in (4,082 mm) to 161.5 in (4,103 mm) across these years.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Every trim has fog lamps in the front bumper: cut-outs in the bumper film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Mercedes SLK-Class, first generation, factory photo
Factory color shown

1996–2004 SLK-Class convertible (first generation)

1996–2004convertible (2 doors)157.3 in (3,995 mm) to 157.9 in (4,011 mm)

Paint age matters on a first-generation SLK-Class, which was built from 1996 to 2004. Panels may be original or repainted, and a test spot comes before a full wrap. Adhesion can vary between old paint and newer paint on the same car. A test spot on each panel helps avoid lifting or damage when the film is removed.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).

Roof, hood, chrome delete and PPF on an SLK-Class

An SLK-Class chrome delete covers the window trim and badges with black film. A partial wrap can include the hood, mirror caps, and rear deck without wrapping the whole car. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. The job size is smaller than a full wrap, so less film and less labor are needed.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mercedes SLK-Class: body, cut-outs and film

The Mercedes SLK-Class vinyl wrap is planned around a compact convertible body that grows slightly with each generation. Length ranges from 157.3 in (3,995 mm) on the earliest cars to 162.8 in (4,134 mm) on the third generation. The fabric top is never wrapped, so the film ends where the top begins. For a folding hard top, the roof panels are wrapped as separate pieces.

SLK-Class wrap ideas start with the bumpers, which need cut-outs for fog lamps on every trim. The third generation adds parking sensors in the bumpers, and the film is cut around each sensor. Door handles and mirrors are removed for a clean edge, and the rear deck is wrapped up to the trunk seam. The open top means there is no roof film to order or fit.

To work out how much vinyl to wrap an SLK-Class, compare the three generations. The first generation needs about 38 ft (11.5 m), while the second and third need about 44 ft (13.5 m). A restyling in 2000 changed the first-generation bumpers, and a 2007 restyling did the same for the second. Chrome or patterned film adds about 5 ft (1.5 m) on every generation because of its layout.

Questions about wrapping a Mercedes SLK-Class

How much vinyl does it take to wrap a Mercedes SLK-Class?

It takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film to wrap the newest SLK-Class body. Chrome or patterned film raises that estimate to about 49 ft (15 m). The estimate is for the third generation, which is the longest at 162.8 in (4,134 mm).

Is the top of an SLK-Class wrapped?

No, the top of an SLK-Class is not wrapped. A fabric top is left uncovered, and the film ends where the top begins. For a folding hard top, the roof panels are wrapped as separate pieces, not as one continuous sheet.

Can I wrap only the hood or the roof of an SLK-Class?

Yes, you can wrap only the hood or the rear deck of an SLK-Class. A partial wrap can include the hood, mirror caps, and rear deck. Chrome delete covers the window trim and badges. Paint protection film (PPF) is a clear film for the front end only.

Is an SLK-Class hard to wrap?

An SLK-Class is not hard to wrap, but it adds work because of the convertible body and the bumper features. The fabric top is not wrapped, so the film must be trimmed cleanly along its edge. The third generation has parking sensors that require individual cut-outs, and every trim has fog lamps that need openings in the bumper film.