Wraps by car

Microcar Virgo wrap

The Microcar Virgo vinyl wrap page covers the 1999–2003 hatchback, the only generation of this mini car. A full wrap of the Virgo takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 43 ft (13 m).

1generations10.5 mof film for a full wrap

Microcar Virgo, first generation, factory photo
Microcar Virgo, first generation. Factory color shown.

Microcar Virgo wrap colors and ideas

  • Virgo black wrap
  • Virgo white wrap
  • Virgo gray wrap
  • Virgo silver wrap
  • Virgo red wrap
  • Virgo blue wrap
  • Virgo green wrap
  • Virgo yellow wrap
  • Virgo orange wrap
  • Virgo purple wrap
  • Virgo pink wrap
  • Virgo teal wrap
  • Virgo brown wrap
  • Virgo gold wrap
  • Virgo chrome wrap
  • Virgo color shift wrap
  • Virgo carbon fiber wrap
  • Virgo camo and patterned wrap

How much vinyl to wrap a Microcar Virgo

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1999–2003hatchback (3 doors)101.6 in (2,580 mm)about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m)

Virgo wrap cost factors

Virgo wrap cost depends on the film type, the amount of disassembly and the condition of the 1999–2003 bodywork. A chrome or patterned film raises material use to about 43 ft (13 m) instead of 34 ft (10.5 m). Removing old paint damage or loose trim adds preparation time.

  • Film for a full wrap: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m).
  • Body: hatchback (3 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Virgo wraps by generation

Swipe sideways. Tap a card for the full description.

Microcar Virgo, first generation, factory photo
Factory color shown

1999–2003 Virgo hatchback (first generation)

1999–2003hatchback (3 doors)101.6 in (2,580 mm)

The first generation Microcar Virgo was built from 1999 to 2003 as a three-door hatchback. Paint age matters because a car of these years may have original or repainted panels. A test spot on the paint comes before a full wrap to check adhesion.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 43 ft (13 m).

Roof, hood, chrome delete and PPF on a Virgo

A full wrap is not the only option for a Microcar Virgo. Partial wrap jobs on this car include the roof, hood and mirror caps. Chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is a clear film applied to the front end.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Microcar Virgo: body, cut-outs and film

A Microcar Virgo vinyl wrap suits the car’s compact 101.6 in (2,580 mm) length and three-door hatchback shape. The small panels keep material use low, but the tall roof and curved corners need careful stretching. A single installer can reach most areas without a ladder.

Virgo wrap ideas start with the two long side doors, each covered by one large piece of film. The tailgate has the rear glass set into it, so the film ends at the edge of the glass. You leave cut-outs for the door handles, badges and the rear wiper.

Knowing how much vinyl to wrap a Virgo means checking whether your car is original or repainted. For this single generation, the body dimensions do not change, so the film estimate stays the same. The figure of 34 ft (10.5 m) covers the full exterior with standard cast film.

Questions about wrapping a Microcar Virgo

How much vinyl does it take to wrap a Microcar Virgo?

It takes about 34 ft (10.5 m) of 60-inch (1.52 m) cast film to wrap a Microcar Virgo. Chrome or patterned film needs about 43 ft (13 m) because of extra material for matching patterns.

Can I wrap only the hood or the roof of a Virgo?

Yes, you can wrap only the hood or the roof of a Virgo. Partial wrap options for this car include the roof, hood and mirror caps.

Is a Virgo hard to wrap?

A Virgo is not hard to wrap, but its long side doors and tailgate glass add work. Each door is one large piece of film, and the film ends at the edge of the rear glass. The small size means fewer seams overall, though curved corners need care.

How many generations of the Virgo does this page cover?

This page covers one generation of the Microcar Virgo, produced from 1999 to 2003.