A full color change on the Paceman wrapped in purple is a large job because the film covers the whole body, not just panels. The side doors are long, and each one is wrapped as one large piece of film. The rear tailgate has the glass in it, so the film ends at the edge of the glass. Every trim has fog lamps in the front bumper, so the bumper film needs cut-outs.
The factory paint is the base for the wrap and should be clean and smooth before the film goes on. Seams are where two pieces of film meet, and on this car they are placed along body lines and edges. The tailgate seam runs right under the rear glass, and the door seams follow the shut lines. A good installer makes the seams tight and even so the wrap looks like paint.
This purple wrap is removable and can be taken off later without leaving adhesive on the paint, if it was installed correctly. Hand wash the wrapped Paceman with a soft sponge and mild soap; do not use automatic car washes with brushes. The film can be cleaned with a detailing spray or a wrap-specific cleaner. Careful washing keeps the finish looking its best.


