A color change wrap on the eK Sport in orange starts with picking a finish, then a film, and then deciding between a full or partial wrap. The eK Sport is a 133.7 in (3,395 mm) five-door van that needs about 49 ft (15 m) of 60-inch (1.52 m) cast film for a full wrap. Sliding side doors mean the door tracks stay bare and the film is cut along them. Matte and satin films hide surface flaws better than gloss.
Factory paint on the eK Sport can show through at door edges and under trim if the wrap is not cut carefully. Seams are placed along panel gaps and body lines, so the sliding door tracks are left bare and the film stops there. A full wrap covers the outside paint, but door jambs and engine bay edges stay in the original color. This keeps the orange wrap clean and avoids lifting at the tracks.
The orange wrap on the eK Sport is removable, and hand washing keeps the film clean without peeling edges. Use a mild detergent and a soft cloth or sponge, avoiding high-pressure water near panel edges and the sliding door tracks. Removing the wrap should be done carefully to avoid pulling paint, especially on older repainted areas. No special coating is needed for normal care.


