Choosing a color shift film for the Plus 4 starts with the finish, then the film, then full or partial coverage. A Plus 4 wrapped in color shift film can look silver on one panel and blue on the next if the film is not oriented the same way. Installers lay every panel with the film running in one direction to keep the color change consistent. The wrap color you see on a flat swatch will deepen and travel over the Plus 4's curved fenders and hood.

Factory paint on the Plus 4 matters because the wrap does not hide deep stone chips or scrapes. Clean, smooth paint lets the color shift vinyl sit flat and reduces seams on body curves. Any rust or lacquer checking on older Plus 4 panels must be corrected before film goes on. Seams are planned along the Plus 4's body edges and behind the doors where they are less visible.

Color shift wrap on the Plus 4 is removable when it is time to change the look or return the car to standard. Hand wash the wrapped body with a pH-neutral car shampoo and a soft mitt because brushes can lift edges. Avoid hot high-pressure water aimed at seams around the grille, running boards and rear wings. The open-top cockpit means you also wipe down wrapped surfaces inside the door tops after rain.