A Pixo wrapped in red starts with choosing the finish that matches the look you want, from flat matte to deep gloss. The next step after the finish is picking a film line within it, because texture alone does not tell you how a film handles. The final decision is whether to wrap the full car or only selected panels. A color change wrap on this car can be done all over or just on the roof, hood, and mirrors.
The factory paint on a Pixo is usually sound before wrapping, but any chips or scratches should be corrected first because film follows the surface. The tailgate has the rear glass within it, so the film ends at the edge of the glass and leaves a clean border rather than wrapping into the opening. A full wrap is planned so the few seams land on body lines, not on flat panels where they would catch the eye. This makes the red look even across the car.
A red wrap on a Pixo is removable, and when installed correctly it leaves no adhesive on the paint below. Hand wash the car after the wrap is applied, using a soft sponge and a mild cleaner. Avoid automatic brushes and pressure washers pointed at edges, because they can lift the film. This basic care keeps the finish even and the edges down.


