Choosing a Pixo wrapped in color shift film starts with the finish, because each finish reads differently on a small hatchback. Gloss color shift film gives the Pixo the deepest wet look and the strongest angle change. Satin color shift film softens the shift and hides small panel waves on the flat sides. Matte color shift film mutes the effect the most and looks more like a colored wrap than a chameleon wrap.

The next decision is the film line and its color range, not the factory paint underneath. The Pixo has a simple body with a tailgate where the rear glass is in the panel, so the color change wrap ends at the edge of the glass. Seams are most likely where the roof meets the quarter panels and around the rear bumper. A good installer will split the front and rear bumpers in the same way on both sides.

The last decision is full or partial: a full color change wrap covers the outside paint, while a partial wrap leaves most of the car original. The film is removable, so the Pixo can go back to its original color when you want. Wash a wrapped Pixo by hand with a soft mitt and pH-neutral soap. Avoid automatic brushes and pressure washers close to edges, because they can lift the film.