For a Serena wrapped in orange, decide the finish first, because each finish changes the effect. Matte hides body lines and makes the color look drier, while satin sits between matte and gloss with a soft glow. Gloss and metallic finishes make the flat panels look deeper and show more reflection. After the finish, pick a film from the list, then choose a full or partial wrap.
The factory paint under the wrap should be clean and in good condition before the film goes on. Seams will fall along panel edges and around the sliding door tracks on every Serena. The installer plans the seams where the film naturally ends at doors and roof rails. Orange film shows seams less than very light colors, but they are still visible up close.
A color change wrap is removable, so the orange can be taken off later without leaving adhesive behind. Hand wash the wrapped Serena with a soft mitt and a pH-neutral soap to avoid lifting edges. Avoid automatic car washes with brushes, because they can catch the film at the door tracks. Rinse the lower panels often to keep road film from staining the orange.



