Choosing a Skyline Crossover wrapped in color shift film starts with the finish, from gloss to satin to matte, because the same pigment reads differently in each. Then pick the film line you like from the 233 films in this color, since film thickness and conformability differ. Decide between a full color change wrap and a partial one like a roof or hood before the installer orders the panels. The first-generation body has a tailgate with the rear glass in it, so the film ends at the edge of the glass and a full wrap needs careful planning there.
Factory paint under the wrap determines how the color shift film sits, because stone chips or peeling clear coat will show through as texture. Seams are placed at body lines where two panels meet, so on a five-door SUV the tailgate and doors get most of the visible edges. A repainted panel may hold film differently from an original one, which is why a test spot goes on before the full wrap. The rear glass in the tailgate means the installer cannot wrap over the glass, only up to its edge.
Color shift film is removable, so a later owner can have the original paint back after the wrap is peeled off. Hand wash the wrapped Skyline Crossover with a mild soap and a soft mitt, because a pressure washer can lift an edge. Cleaning the film regularly stops dirt from grinding into the surface and dulling the shift effect. Use no solvent-based cleaners on the wrap.

