An Adam wrapped in gold starts with the finish, because that decides how the color looks on the car. Matte gold is flat and modern, satin has a soft sheen, and gloss reflects the most light and looks closest to paint. The color change is then a choice of film from the catalog, where every film has its own tone from pale champagne to deep bronze. After the film, decide between a full wrap or leaving some panels in the factory color.

Factory paint on the Adam matters because the film only hides what is under it. Deep scratches, stone chips and failing clear coat can show through the film as small marks. A test spot on an older or repainted panel tells the installer if the paint will hold the film. The body has a tailgate with the rear glass in it, so seams are planned around the glass edge and the film ends there.

A gold wrap on the Adam is removable, but the best adhesion needs clean, smooth paint. Hand wash with a soft mitt and a mild cleaner keeps the film clean without lifting edges. Avoid automatic brushes and pressure washers aimed at film edges. The two long side doors are each one large piece of film, so they are less likely to lift than many smaller pieces.