A ReHigh RH6 wrapped in yellow is a full color change, not a temporary tint. The first decision is the finish: matte, satin, gloss, or something like metallic or fluorescent. Then pick a specific film line, because even two gloss yellows can look different in hand. Finally decide between a full wrap and a partial job like the roof and hood, which changes the amount of film and the look.

Factory paint needs to be clean, smooth, and free of chips or peeling clear coat before film goes on. Any deep scratch or rock chip will show through the wrap, so light paint correction makes the result cleaner. Seams are unavoidable on a sedan this size because the film comes in standard 60-inch (1.52 m) rolls. A good installer hides seams along body lines, under edges, and around the charge port door.

A yellow wrap is removable when it is installed and cared for correctly. Hand wash the wrapped RH6 with a soft mitt and pH-neutral soap, and avoid automatic brushes that can lift edges. The wrap can be removed later without changing the factory paint underneath. Removal is cleaner when the film has not been baked by prolonged sun and when edges are still fully sealed.