A Smart #1 wrapped in camo or patterned film starts with the finish, and the three groups on this page each have their own look. Honeycomb films read as a black texture with a repeating hex pattern, while brushed metal films have a linear metallic grain. Camouflage and snakeskin films bring the strongest pattern, and they usually cost more film because the pattern must line up across panels. After the finish comes the film line, then the decision between a full wrap and a partial one.

The factory paint on the #1 does not change the work much, because the wrap goes over clean paint and is removable later. Seams are part of a wrap, and the installer can hide them in body lines and around the glass roof edge. On the #1 the tailgate has the rear glass in it, so the film ends at the edge of the glass. Any styling kit on the bumpers and sills means more separate pieces to cut and fit.

Camo and patterned wrap film on a #1 is removable, and a careful hand wash is the way to keep it clean. Avoid automatic car washes with brushes, because they can lift the edges of the film. Use a pH-neutral car shampoo and a soft mitt, then rinse with low pressure. The film needs the same care on the charge port door, which is wrapped as a small piece of its own.