A #3 wrapped in red is a color change over the factory paint, so the film hides the original color completely. Start by deciding the finish: matte, satin or gloss red all read differently on the same body. Then choose a film from the 226 red options on this page. Finally decide whether to wrap the whole SUV or just selected panels.

Factory paint stays untouched under the film, which is useful when you want a red #3 without a permanent paint job. Seams are part of every wrap, and they are placed at panel edges or body lines so they are less visible. On the #3, the tailgate and bumpers give the installer natural places to end each piece. A good installer plans the seams before cutting any film.

A red wrap is removable, so you can return the #3 to its factory paint later. Hand wash is the safest way to clean the film, because brushes and high-pressure jets can lift an edge. Wash with a soft mitt and mild soap, then rinse thoroughly. If you must use a pressure washer, keep it on low pressure and away from the film edges.