A Roadster wrapped in color shift film starts with the finish, because a color change can go from subtle to extreme. Layering a colored tint over the paint creates a deep look without hiding the factory color underneath. Leaving the factory paint fully covered gives the Roadster an entirely new identity. The 43 ft (13 m) of film for the convertible second generation leaves the roof as the only unpainted limit.
Factory paint condition decides how a color shift wrap sits on the Roadster. The film shows every scratch and chip through the surface unless the panels are prepared first. Seams on the 155.4 in (3,946 mm) first generation and the 177.2 in (4,500 mm) second generation follow the natural body lines. The wrap ends where the fabric top begins, so there is no need to lift the roof mechanism.
Removable color shift film comes off the Roadster without leaving adhesive behind. The finish stays cleanest with a hand wash and a soft mitt, because brush bristles can lift an edge. The charge port door is wrapped as a small piece of its own, so it can be replaced alone if it gets scratched.
