Wraps by car

Tofas Murat 131 wrap

This page covers the Tofas Murat 131 wrap for one generation, produced from 1985 to 1995. A full vinyl wrap of the sedan takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds roughly 30 percent to the amount. The data below help you plan film and labor for this compact car.

1generations14.5 mof film for a full wrap

Tofas Murat 131, first generation, factory photo
Tofas Murat 131, first generation. Factory color shown.

Tofas Murat 131 wrap colors and ideas

  • Murat 131 black wrap
  • Murat 131 white wrap
  • Murat 131 gray wrap
  • Murat 131 silver wrap
  • Murat 131 red wrap
  • Murat 131 blue wrap
  • Murat 131 green wrap
  • Murat 131 yellow wrap
  • Murat 131 orange wrap
  • Murat 131 purple wrap
  • Murat 131 pink wrap
  • Murat 131 teal wrap
  • Murat 131 brown wrap
  • Murat 131 gold wrap
  • Murat 131 chrome wrap
  • Murat 131 color shift wrap
  • Murat 131 carbon fiber wrap
  • Murat 131 camo and patterned wrap

How much vinyl to wrap a Tofas Murat 131

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1985–1995sedan (4 doors)170.1 in (4,320 mm)about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 61 ft (18.5 m)

Murat 131 wrap cost factors

A Murat 131 wrap cost depends on the film type and the amount of labor on this 170.1 in (4,320 mm) sedan. A full color change uses about 48 ft (14.5 m) of cast film, while chrome or patterned film raises the total to about 61 ft (18.5 m). Door jambs, deep recesses, and bumper coverage add time and material. Whether your car has original paint or a respray changes the prep work before wrapping.

  • Film for a full wrap: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 61 ft (18.5 m).
  • Body: sedan (4 doors).

Murat 131 wraps by generation

Swipe sideways. Tap a card for the full description.

Tofas Murat 131, first generation, factory photo
Factory color shown

1985–1995 Murat 131 sedan (first generation)

1985–1995sedan (4 doors)170.1 in (4,320 mm)

The first generation Tofas Murat 131, built from 1985 to 1995, often has paint of unknown age. Panels may be original or repainted, and a test spot on a small area shows if the film will lift old paint. If the test fails, you may need to sand and prime the bad areas before a full wrap. This extra prep is specific to older cars like this one.

Film: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 61 ft (18.5 m).

Roof, hood, chrome delete and PPF on a Murat 131

A partial wrap on a Murat 131 can cover just the roof, hood, or mirror caps without wrapping the whole car. A chrome delete turns the window trim and badges black with film, but you leave the rest of the paint alone. Paint protection film (PPF) is a clear shield that goes on the front end to guard against chips. These smaller jobs use less film and take less time than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Tofas Murat 131: body, cut-outs and film

A Tofas Murat 131 vinyl wrap is a straightforward job on a four-door sedan with a length of 170.1 in (4,320 mm). The flat panels and simple curves of this compact body reduce the need for stretching film. Only one body style exists in this generation, so film estimates stay the same for every car. The roof, hood, trunk, and four doors make up the main wrapped areas.

Murat 131 wrap ideas work best when you plan for the trim and hardware on this car. The door handles, mirrors, and window trim need cut-outs or removal before the film goes on. The bumpers and grille are separate parts that you can keep unwrapped or cover in a contrasting finish. Taking off badges and side moldings gives cleaner edges and fewer seams.

To figure out how much vinyl to wrap a Murat 131, check the single generation offered from 1985 to 1995. The body length did not change during these years, so the same estimate applies to early and late cars. The sedan shape means you order one consistent amount for every project. Paint condition can change how much extra film you need for test pieces or re-dos.

Questions about wrapping a Tofas Murat 131

How much vinyl does it take to wrap a Tofas Murat 131?

A Tofas Murat 131 full wrap takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, plan on about 61 ft (18.5 m). These amounts cover the sedan body from 1985 to 1995.

Can I wrap only the hood or the roof of a Murat 131?

Yes, you can wrap only the hood or the roof of a Murat 131. The partial jobs on this car include the roof, hood, and mirror caps, as well as a chrome delete for the window trim and badges.

Is a Murat 131 hard to wrap?

A Murat 131 is not especially hard to wrap, but the size of 170.1 in (4,320 mm) and the sedan shape mean you have four doors and large flat panels to handle. The trim, handles, and bumpers need cut-outs or removal, which adds labor. The oldest paint can be fragile, so a test spot is wise before film goes on.

How many generations of the Murat 131 does this page cover?

This page covers one generation of the Murat 131, produced from 1985 to 1995. The catalog lists the first generation as the only body for this model.