A color change wrap for an Estima in red starts with the finish, from matte and satin to gloss and textured films. Next choose a film line that your installer works with, because handling differs at the sliding door rails. The third decision is full or partial coverage, and the roof adds 70.3 in (1,785 mm) of height on the third generation.

Factory paint on an Estima stays covered, so you see the film color on the outside but the door shuts and engine bay keep the original shade. Seams are planned at panel edges and along the sliding door tracks, where the film must be cut. A good installer trims these edges cleanly so the wrap follows the trim lines.

A red wrap on an Estima is removable and can be taken off without leaving adhesive on healthy factory paint. Hand wash the vehicle and avoid automatic brush washes, which can lift a film edge. Dirt at the bottom of the sliding doors is best cleaned gently with a soft mitt.