A Prius Plug-In wrapped in gray begins with the finish, then the film, then how much of the car to cover. Matte gray hides fingerprints and softens the body lines, while satin gives a low sheen that stays clean. Gloss gray is the closest match to factory paint and reflects the most light. On this car the tailgate is a one-piece wrap because the rear glass is set into it, so the film ends at the glass edge.
Factory paint condition decides how the gray wrap sits, and seams are placed where the body already has lines. On the Prius Plug-In the film is cut around the camera lenses and fog lamps in the bumpers, so the seams stay small and close to each cut-out. The charge port door is wrapped as a separate piece, which keeps the edge clean on plug-in and electric versions. If the paint has chips or deep scratches, they need to be leveled before the film goes down.
A gray color change wrap is removable by a trained installer, so the factory paint underneath is not permanently changed. Hand wash the wrapped Prius Plug-In with a mild soap and a soft mitt instead of an automatic brush wash. Dirt around the charge port door and the camera lenses should be wiped off by hand to keep the film edges down. If you only want a few panels, the roof, hood and mirror caps can be wrapped as a smaller job.

