A Meriva wrapped in yellow is a full color change that hides the factory paint completely. Choose the finish first, because matte, satin and gloss each change how the yellow reads on the van's tall sides. Then pick a film brand from the page's 114 yellow films, and decide between a full wrap and a partial one covering just the roof and hood. The second generation's sliding doors mean the wrap stops at the tracks, which keeps the look clean.

Factory paint condition decides how much preparation a yellow wrap needs on a Meriva. Check every panel for chips, deep scratches or rust before the film goes on. Any damaged area must be sanded and primed, otherwise the wrap shows the defect. The sliding door tracks stay bare, so the installer cuts the film along them and hides the seams there.

The yellow wrap on a Meriva is removable and leaves the factory paint as it was. Care is simple with hand wash only, using a soft sponge and pH-neutral soap. Avoid automatic car washes, because brushes can lift the film at the door edges. When you remove the film later, no adhesive residue stays behind if the paint was healthy before the wrap.