A VF5 Plus wrapped in yellow starts with picking the finish, then the film line, then the coverage area. The film estimate for this SUV is about 52 ft (16 m) of 60-inch (1.52 m) cast film for a full color change. Partial wraps use less film and leave the factory paint visible on most panels. The color change wraps the painted surfaces without altering the original body.

The factory paint underneath does not need to be yellow, but small chips should be touched up before wrapping. Seams are placed along panel edges and body lines where a wrapped edge has to end. The charge port door is wrapped as a small separate piece so it can open normally. Dark factory paint can show through light yellow film if the film is very thin.

A removable color change wrap peels off the VF5 Plus without leaving adhesive on the paint. Hand wash with a soft sponge and pH-neutral soap to protect film edges and seams. Avoid automatic car washes with brushes because they can lift the film at edges. Rinse off bird droppings and tree sap early to keep the yellow surface clean.