A Mix wrapped in black starts with choosing the finish, because the same black can look matte, satin or gloss. The color change means the film, not the factory paint, decides the surface light plays on. The sliding side doors keep this car easier to panel than a long SUV. Matte and satin read as flatter on the van's tall sides.

Factory paint does not need to be perfect before a wrap, but any deep scratch or rust spot will show through the film. Seams on the Mix run next to the sliding door tracks, so the installer can hide them along the body lines. The hood and roof are large enough for single sheets with no center seam. This body has no sharp fender flares that would force extra seams.

The wrap is removable, so the factory paint stays in place under it until you decide to change the look. Hand wash the Mix with a soft sponge after wrapping to keep the edges clean. A pressure washer is fine only when held at a distance and away from film edges. The film needs no wax or polish to hold its black finish.