Choosing a color shift film for the ZMAG starts with the finish, then the exact film, then full or partial coverage. The color change looks different depending on the light and the angle of each panel, so the same film can read as two tones on one SUV. For a full wrap, order enough film to cover the whole body plus extra for the open-top edges and the tailgate. A partial wrap in color shift film is a lower-material way to test the look on the hood and mirror caps first.

The factory paint stays under the wrap and needs to be clean and smooth before the film goes on. Any chip or scratch in the paint can show through the color shift vinyl as a small bump or line. Seams fall on the edges of the open-top body, where the fabric top meets the body panels. The film ends at the edge of the rear glass in the tailgate, so the seam follows that line.

A color shift wrap on the ZMAG is removable when you want to go back to the original paint or change films. Hand wash the wrapped SUV with a soft mitt and a mild soap, and avoid brushes that can lift the edges of the film. The removable vinyl does not bond permanently to the paint, so the body can be returned to stock. A good installation makes the wrap look as smooth as paint and easier to clean than a rough surface.