A color change on the FRV (BS2) starts with choosing the finish you want on the car. A matte gray hides waves better than a gloss, while a satin gives a soft sheen without the full shine. Pick a film line you trust, then decide if you want the whole body wrapped in gray or just some panels. The finish choice changes how the car reads from across a parking lot.
Factory paint condition matters when you wrap an FRV (BS2) because the film follows the surface under it. A car with original paint may have chips or scratches that need filling before the wrap. Seams are another point: a gray film can be placed so the visible edges follow the door shut lines and the rear glass edge. A good installer plans the seams before cutting the first panel.
A gray wrap on the FRV (BS2) is removable when you use a quality cast film and a clean paint surface. The adhesive is designed to release without pulling factory paint when the paint is sound. Hand wash the car with a soft mitt and a mild car shampoo, and avoid pressure washers aimed at the edges. Removable does not mean you can peel it off after a week without any care.


