A Brilliance H230 wrapped in green starts with choosing the finish, then the film, then whether to wrap the whole car or only parts. Matte and satin films hide uneven paint and keep reflections low, while gloss and metallic films show deeper color on a finish that looks closer to fresh paint. The hatchback and sedan use the same panel plan, so the finish choice does not change the amount of film. Partial wraps on the roof, hood, or mirror caps lower the film amount for a smaller color change.

The factory paint decides how much preparation the H230 needs before a green wrap goes on. Every chip, scratch, and rust spot must be repaired because film follows the surface and shows the damage through it. On this car the film ends at the edge of the rear glass on the tailgate, which avoids seams in the middle of the panel. Some trims have parking sensors and fog lamps that get cut-outs in the bumper film to keep their function.

A green wrap on the H230 is removable, so the original color stays under the film and comes back when you take it off. Hand wash the car with a soft mitt and a mild cleaner, and avoid brushes that can lift the edges of the film. Rinse the lower panels and wheel arches more often because they collect more dirt. Do not pressure-wash close to seams or sensor cut-outs, since water can get under the film.