The first decision on a BYD F0 wrapped in brown is finish, because it changes the whole character of the color change. Matte brown reads as a calm, non-reflective surface that suits the car's small upright body. Gloss brown brings out the curves of the five-door hatchback and looks closest to a fresh paint job. Satin sits between them with a low sheen that hides fingerprints better than gloss.

Factory paint on the BYD F0 must be clean and smooth before brown film goes on, because every chip or scratch can show through. On this body the side panels are short, so one piece often covers each door and quarter with fewer seams. The roof is a simple shape that installers can wrap in one sheet without a seam down the middle. Around the tailgate the film ends at the edge of the rear glass to avoid lifting at the seal.

A brown wrap on the BYD F0 is removable when it has been installed on undamaged factory paint. Hand wash the car with a soft sponge and mild soap to keep edges down and the finish clean. Do not use automatic brushes or high-pressure jets close to film edges, because they can lift the vinyl. If the car will sit outside often, a wax or sealant made for vinyl helps keep the brown surface easy to clean.