Choosing a green wrap for the Bonus 3 (E3/A19) starts with finish, then film, then full or partial coverage. A color change wrap covers the factory paint completely and can be removed later, so the original finish stays protected. For this sedan, the roof and front bumper add the most cutting time because of the fog lamps and sensor cut-outs on some trims. Pick the film line after you decide how deep or flat you want the green to read on the 175.2 in (4,450 mm) body.
The Bonus 3 (E3/A19) factory paint is the base under any green film, so deep scratches or peeling clear coat will show through a thin wrap. Wrap seams land on panel edges, and on this sedan the door shut lines are straight enough to keep them clean. Some trims have parking sensors in the bumpers, so the installer must cut around each sensor without lifting the film edge. Prepping the paint with a clay bar and alcohol wipe is the step that decides how long the film lies flat.
A green wrap on the Bonus 3 (E3/A19) is removable, but the removal must be done with low heat to avoid pulling clear coat from weakened factory paint. Hand wash the car after wrapping because pressure washers can lift edges at the fog lamp cut-outs and mirror caps. Use a pH-neutral soap and a soft mitt, never a brush on the green film. Drying the car with a microfiber towel keeps water spots from etching the surface of matte and satin greens.


