A Tiggo 7 wrapped in yellow starts with the finish decision, because matte, satin and gloss change the look more than the shade. Chrome or patterned film needs about 69 ft (21 m) on this body. After the finish you pick a film line within that finish group. Finally you decide between a full wrap and a partial wrap.

Factory paint condition decides how the film sits, because wrap film follows every stone chip and scratch. Seams are planned around the tailgate glass and the bumper sensors on this car. The installer cuts the film around each parking sensor and camera lens. The 177.4 in (4,505 mm) body has no door jambs on the outside, so the wrap ends at the panel edges.

The film is removable from the Tiggo 7 without leaving adhesive on undamaged factory paint. Hand washing is gentler than automated brushes on wrapped edges and cut-outs. Avoid pressure washers pointed at film edges near the fog lamps and sensors. A color change wrap can be peeled off later by an installer.