Choosing a purple wrap for your Epica starts with the finish, then the film line, then whether to wrap the whole car or just selected panels. For a full color change, the sedan body of the first-generation Epica needs about 59 ft (18 m) of 60-inch (1.52 m) cast film. Matte and satin films hide minor surface imperfections better than gloss, making them a practical choice on a mid-size sedan. Some trims have parking sensors in the bumpers, so the installer cuts the film around each sensor during a full wrap.
Factory paint condition matters before a purple wrap goes on an Epica. Any scratches, chips, or peeling clear coat can show through the film and should be corrected first, because the wrap follows the surface beneath it. The first-generation Epica has fog lamps in the front bumper on every trim, so the installer adds cut-outs in the bumper film around each lamp. Seams are planned along body lines and panel edges, and on this sedan they are most visible at the corners of the front and rear bumpers.
Purple wrap film is removable, but you should still care for it properly. Hand wash the Epica with a mild automotive soap and a soft mitt instead of taking it through an automatic car wash with brushes. Avoid pressure washing directly at film edges, especially around the parking sensor cut-outs on some trims of this first-generation sedan. If the film was recently installed, wait a few days before the first wash so the adhesive can set.


