Your first decision for a Traverse wrapped in chrome is the finish and its tone among the silver, black, gray, red, gold, pink, blue, green and purple films. The silver group has the most mirror-like chrome vinyl, while the blue and purple group runs to satin and prismatic looks. A color change to chrome is always a full wrap because the unprinted film is not a solid color. The last decision is whether the wrap covers the door jambs or leaves the factory paint there.

The chrome film will not hide factory paint that is badly chipped or peeling, so those areas are sanded or primed first. Every panel edge on the Traverse is cut along a panel gap, so the body still shows no seams in the middle of a panel. Seams may be needed on the deep front or rear bumper where a single piece cannot reach. The tailgate film ends at the edge of the rear glass, and cameras and parking sensors are cut out.

A chrome wrap is removable and the goal is to remove it without leaving adhesive on the paint. Hand wash the wrapped Traverse and avoid automatic car washes that push dirt under the film edges. Dry the wrap with a microfiber towel to keep water spots off the chrome face. If you remove the roof rails for the wrap, the same bolts and trim are used to put them back.