A Town & Country wrapped in white starts with the finish first, because matte, satin and gloss read differently on a vehicle this tall. Next choose a film line from the catalog, keeping in mind your budget and the exact white tone you want. After that decide between a full color change or a partial wrap that leaves the factory paint showing. The final call is whether to cover door jambs, which depends on how complete you need the color change.

Factory paint condition decides how much preparation a white wrap needs before any film goes on. Deep scratches and rock chips should be filled and wetsanded, or they will show through lighter films. Seams are placed at panel edges and along the sliding door tracks, where a knife cut follows the track. On this van the tallest areas are the roof and the rear hatch, so the installer works from a platform.

A white wrap is removable, but it still needs care to release cleanly later on. Use a pH-neutral soap and a soft sponge, and avoid brushes that can lift edges. Hand wash only, because pressure washers and automatic car washes push water under the film. Wax is not needed on vinyl, but a spray sealant made for wraps can help release dirt.