Deciding on a Capri wrapped in black starts with the finish, since matte, satin, and gloss each alter the color change effect. The film you pick then determines how the material conforms to the door recesses and the tailgate edge. A full wrap covers every painted panel, while a partial wrap leaves the factory color visible in the roof, hood, or mirror caps. The size of the car fixes the film amount, so a coupe uses about 46 ft of cast film and the SUV uses roughly the same panel count.

Factory paint under a black wrap stays hidden only when the film is opaque enough to block the original shade. Panel gaps and edges create seams where the factory color can peek through if the film is cut too short. On a fourth generation Capri the charge port door is wrapped as its own small piece, leaving two more seams around that flap. A test spot on one panel shows whether the chosen black film reads as a true color change on this car.

A black wrap on any Capri is removable when the film is lifted with heat and a steady pull from one edge. The factory paint underneath returns to its original color if the surface was clean and undamaged before installation. Hand washing with a soft mitt keeps dirt from working under the film edges at the door seams. No wax or solvent cleaner is needed on a wrap, since the film’s own finish does the visual work.