Wraps by car

Geo Storm wrap

The Geo Storm wrap page covers the first-generation 1990–1993 Geo Storm coupe and the vinyl wrap needed for its body. A full wrap of this two-door coupe takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the estimate to about 51 ft (15.5 m).

1generations13.5 mof film for a full wrap

Geo Storm, first generation, factory photo
Geo Storm, first generation. Factory color shown.

Geo Storm wrap colors and ideas

  • Storm black wrap
  • Storm white wrap
  • Storm gray wrap
  • Storm silver wrap
  • Storm red wrap
  • Storm blue wrap
  • Storm green wrap
  • Storm yellow wrap
  • Storm orange wrap
  • Storm purple wrap
  • Storm pink wrap
  • Storm teal wrap
  • Storm brown wrap
  • Storm gold wrap
  • Storm chrome wrap
  • Storm color shift wrap
  • Storm carbon fiber wrap
  • Storm camo and patterned wrap

How much vinyl to wrap a Geo Storm

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1990–1993coupe (2 doors)163.4 in (4,150 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 51 ft (15.5 m)

Storm wrap cost factors

The Storm wrap cost depends on the film left over from a full wrap of this 163.4 in (4,150 mm) coupe, since its two long side doors use one large sheet each. The choice between cast film at about 44 ft (13.5 m) and chrome or patterned film at about 51 ft (15.5 m) changes material use. The condition of the paint on a 1990–1993 panel also affects preparation work before the wrap.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 51 ft (15.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Storm wraps by generation

Swipe sideways. Tap a card for the full description.

Geo Storm, first generation, factory photo
Factory color shown

1990–1993 Storm coupe (first generation)

1990–1993coupe (2 doors)163.4 in (4,150 mm)

The first-generation Geo Storm was produced from 1990 to 1993 as a two-door coupe measuring 163.4 in (4,150 mm) long. Paint age on this car can vary, so a test spot comes before a full wrap to check adhesion on original or repainted panels. The two long side doors are the main wrap surface for this generation.

Two long side doors: each door is one large piece of film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 51 ft (15.5 m).

Roof, hood, chrome delete and PPF on a Storm

A partial wrap on a Geo Storm can cover the roof, hood, or mirror caps without wrapping the whole coupe. A Storm chrome delete covers the window trim and badges with black film. Clear paint protection film (PPF) on the front end is another smaller job.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Geo Storm: body, cut-outs and film

A Geo Storm vinyl wrap covers one compact coupe body style with two doors and a length of 163.4 in (4,150 mm). The two long side doors are each one large piece of film, so the wrap uses full-width panels without seams on the doors. The coupe's compact size keeps the total film estimate lower than a larger car.

Storm wrap ideas can include covering the two long side doors with single large pieces of film for a clean look. The door handles and mirrors need cut-outs or removal before the film goes on. The bumpers and front end also come off for a neater edge.

How much vinyl to wrap a Storm stays the same across the single generation, since only the 1990–1993 coupe is listed. Without other generations to compare, the estimate of about 44 ft (13.5 m) of 60-inch (1.52 m) cast film applies to all Storm coupes. Chrome or patterned film adds about 7 ft (2 m) to the total.

Questions about wrapping a Geo Storm

How much vinyl does it take to wrap a Geo Storm?

A full wrap of a Geo Storm takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film needs about 51 ft (15.5 m). The estimate covers the two-door coupe body of the first generation.

Can I wrap only the hood or the roof of a Storm?

Yes, you can wrap only the hood or the roof of a Storm, as partial wrap options include the roof, hood, and mirror caps. Chrome delete and paint protection film are other smaller jobs. These use less film than a full wrap of the coupe.

Is a Storm hard to wrap?

A Storm is not hard to wrap, but the two long side doors each need one large piece of film, which adds handling work. The compact length of 163.4 in (4,150 mm) and the simple coupe shape keep the job straightforward. Careful installation on the long doors is the main challenge.

How many generations of the Storm does this page cover?

This page covers one generation of the Geo Storm, the first generation from 1990 to 1993. The catalog lists a single generation for this car, so all wrap estimates refer to that coupe.