A Hover M2 wrapped in green starts with choosing the finish because matte, satin, gloss, metallic, and fluorescent reads very differently on this upright SUV body. After the finish you pick a film line that fits your installer's method and the look you want. Then you decide between a full color change wrap and a smaller job like the roof, hood, and mirror caps.
The factory paint matters because the film adds a new layer over it and any deep chips or rust will show through. The rear glass is set into the tailgate so the film ends at the edge of the glass on this body. Seams are planned around the lamp and sensor cut-outs in the bumpers. A clean, smooth surface gives the installer the best base for an even green finish.
Green wrap film is removable when it is time to return the Hover M2 to its factory color. Use a pH-neutral car shampoo and hand wash the wrapped body because high-pressure washers can lift edges. Avoid scrubbing the film with brushes because that dulls matte and satin green faster.


