A Hover M4 wrapped in color shift film starts with choosing a finish group. The group sets the base tone, from a gray or black shift to pink, gold, orange, purple, blue or green. Then pick a film within that group, because each film has its own color travel and gloss level. The color change covers every painted panel, so the car reads as one new color.

Factory paint condition decides how much preparation a color shift wrap needs. Deep scratches, chips and rust show through the film, so they should be repaired first. The Hover M4 has a tailgate with the rear glass in it, and the film ends at the edge of the glass. Seams may be needed around the rear glass and bumper cut-outs, but a good installer hides them along body lines.

A color shift wrap is removable when the film is intact and the factory paint was sound before installation. Hand wash the wrapped Hover M4 with a soft mitt and pH-neutral car shampoo. Avoid pressure washers close to edges, door handles and sensor cut-outs. This keeps the film edges down and the color travel even.