A Boliger wrapped in color shift film starts with choosing the finish that suits the light where you drive. Pick the film first, because the finish determines how the shift reads on the big side panels. Color change works best when the panels are clean, smooth and free of deep scratches. Then decide between a full wrap and a partial color change wrap.
Factory paint is the base for every color shift vinyl, so it must be sound before the film goes on. Seams will show where a panel ends, and on this tall SUV the roof is wrapped from a platform to keep them tidy. The installer plans seams along body lines, and the tailgate film ends at the edge of the rear glass. Good paint preparation keeps the film flat and the seams narrow.
Color shift film is removable and comes off without leaving adhesive on healthy factory paint. Hand wash the wrapped Boliger with a soft mitt and pH-neutral soap, and avoid pressure washers at the edges. A removable film means you can return the car to its original color when you sell it.

