A Boliger wrapped in orange starts with the finish, because matte, satin, and gloss read differently on this SUV's large panels. Then you pick a film line within that finish, where 93 films give you shades from bright signal orange to burnt orange. The third decision is full or partial, since a color change wrap can cover the whole body or just the roof, hood and mirrors. On this car the tall sides and tailgate mean a full wrap uses about 62 ft (19 m) of film.

Factory paint stays visible where the wrap film is cut, so orange film over dark factory paint makes the cut edges show more at door jambs and panel gaps. A good installer plans seams along body lines and edges, not across a large flat panel. The Boliger's tailgate holds the rear glass, so the film ends at the edge of that glass. Seams are also needed around the roof opening, because every trim of this car has a sunroof.

A removable vinyl wrap lets you return the Boliger to its factory paint when you sell it or change color. Hand wash the wrapped car with mild soap, and avoid pressure washers close to film edges. Any wax or sealant you use must be safe for vinyl film. The wrap film itself is not permanent, so you can peel it off without repainting.