A JAC J7 wrapped in color shift film starts with choosing the finish, because every film moves between two or three tones. Matte and satin films soften the shift, while gloss films make the color change look faster and deeper. Then pick a film line that fits your goals: a budget film can still look good, but a cast film conforms better to the J7's curves. Decide between a full color change and a partial wrap, like the roof and hood only.

Factory paint on the JAC J7 only needs a clean, decontaminated surface before the color shift film goes on. The installer will check for stone chips and deep scratches, because film shows every defect underneath. Seams are placed along body lines and panel edges, so they stay tidy on this sedan. A color shift film makes seams more visible than a solid color, since the shift direction changes at each cut.

Color shift vinyl is removable, so the wrap can come off without changing the J7's factory paint when it was applied to healthy paint. Hand washing is enough for a wrapped car, and that keeps the edges from lifting. Avoid automatic brushes and pressure washers aimed at film edges. If you remove the wrap yourself, use heat and pull slowly at a low angle.