A JAC S6 wrapped in blue starts with finish before anything else. Matte and super matte films give the large side panels a flat, modern look that reads almost like a factory primer color. Satin sits between matte and gloss, with a slight sheen that moves across the tailgate and rear quarters. Gloss and metallic films add reflections that make the blue look deeper on the hood and roof. Once you know the finish you like, pick a specific film from the 436 options on this page.
Factory paint condition decides how a blue color change wrap sits on your JAC S6. Any chip or scratch shows through the film, and matte finishes make these marks more obvious than gloss does. The hood and front bumper take the most stone damage, so clean and repair those panels first when the paint is worn. The rear bumper and tailgate rarely need bodywork, but they must be degreased before the blue film goes on. Seams in the vinyl wrap fall on panel gaps and around the handles, not across open sheet metal.
A blue wrap on the JAC S6 is removable when you want a change or a lease return. The film lifts with heat and leaves the factory paint as it was, as long as the paint was not already peeling before the wrap went on. Hand wash the wrapped car with a soft mitt and pH-neutral soap, and rinse road salt off the lower doors and rockers. Avoid pressure washers on edges, because they can lift the film and let water under a seam.


